Gridfinity Magnet Base Improved - all sizes up to 13x12, 6mm and 5mm magnets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Magnetic Gridfinity base plate with more functionality for less filament
- Rating
- 4 / 5
- Likes
- 29
- Downloads
- 238
- Makes
- 1
- Views
- 1,443
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Baseplates for Gridfinity, with that satisfying magnetic snap.
Based on the proven Gridfinity Extended “Efficient Magnetic Base”, with a number of improvements:
- Friction fit for magnets, no glue needed
- Extraction holes for magnets, use tweezers to retrieve them when you decommission old base plates
- Magnets covered by thin roof to prevent bins from pulling out magnets
- Perimeter cutouts: bins are held on at the corners and guided by sloped surfaces
- Cutouts for 5x5x1.5 butterfly clips to align multiple plates (glue recommended)
- Square corners to fit your drawers
- 15% less filament used at same settings
The base plates hold gridfinity containers at the same height as Gridfinity Extended magnetic base plates. These plates fit 6x2mm magnets and 6x1mm magnets. If the fit of the magnets is off either print a calibration cube and adjust your filament settings accordingly, or adjust the X-Y hole compensation in your slicer.
For ready-made Orca Slicer/Bambu Studio print profiles for 0.4 and 0.6 nozzles for sizes up to 6x6 check out my Makerworld version