Cisco 88XX Phone Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A clip-in phone stand, designed for the Cisco 8861, which tilts the phone down more than the OEM stand.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 97
- Makes
- 0
- Views
- 389
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
I was unhappy with the way my Cisco 8861 sat on my desk. It was angled in a way that reflected my ceiling lights.
Using the clip geometry from r9l, I cut off the rest and remodeled a stand that will hold the phone vertically on the desk at ~10 degrees. It includes a hole to pass through the Ethernet cable, but the cables fit fine just going out the side as well, albeit a little cramped.
In my slicer I sat it on its side (with the side where two clips are closer together facing down) and for supports I used snug supports and manually painted the supports on the bottom of the clips (the 3 that need it) and inside the eth. passthrough.
All screenshots/pictures are from the previous iteration, which did not have the cable passthrough.