Sherpa Mini Filament Cutter

This is a filament cutter remixed to place the cutter arm in the rear left instead of front left. I am using this on my Voron 2.4 with Monolith AWD with Archetype blackbird toolhead. Placing the arm in the rear eliminates the build area loss related to the push bar, as it cuts the filament behind the build plate. I am using this to in combination with the purge bucket/silicone wiper mod with an Annex TradRack.

You'll need to create a macro to cut the filament, and this will depend on your printer/mounting. Just note the positions of the following while moving your toolhead: 1)position near push block, 2)position where it push block touches arm of cutter, 3) position where cutter arm is activated (this will be a movement to the left and forward). Then create your macro to do 1,2,3,2.

Hope this helps someone!