Stand for floating KINDER JOY figures

we have a lot of these figures and before they just lie around I thought I'd do something fun

what you need
 

1x superglue
1x Kinder Joy figure (I used the ones that are intended for cables, others will probably work too)
1x round magnet 6mm that you stick into the head of the figure
1x round or square magnet for the top A part (I used a 10x20mm magnet)
    use the Top A customizable Fusion file to adjust your magnet
1x a piece of fishing line or a nylon line that is as thin and transparent as possible
1x screw m3x8 (or superglue)
1x the printed parts

how to

open the figure and glue the round magnet (6mm) into the top opening of the head

you can knot or glue the cord into the figure (leave the cord longer because the distance still needs to be adjusted)

close the figure

print all parts

insert the RAIL into the TOP A part and fix it with the PIN you can use superglue

now insert the RAIL into the BASE and screw it down at the bottom with the m3x8 screw or use superglue

now lead the end of the cord that the figure is hanging on through the opening in the BASE

now put the stand up and put the magnet (of your choice) in TOP A

now lead the figure up until the magnetic field attracts the figure (it must not touch TOP A)

if the distance is right you can knot the cord at the bottom of the holders in the BASE

insert TOP B into TOP A and the model is finished

the stronger the magnets are, the higher the distance possible

if you have problems adjusting your magnet send me a PM with the dimensions of your magnet and I will create the file for you