1 / 7
Trichter abgewinkelt Bernardo P600G Getriebeöl; Angled funnel Bernardo P600G gear oil — image 1
1 / 7

Trichter abgewinkelt Bernardo P600G Getriebeöl; Angled funnel Bernardo P600G gear oil

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Trichter abgewinkelt Bernardo P600G Getriebeöl; Angled funnel Bernardo P600G gear oil

Rating
0 / 5
Likes
4
Downloads
43
Makes
0
Views
351
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Abgewinkelter Trichter für das Vorschubgetriebe der Bernardo P600G. 
Ein O-Ring mit Innendurchmesser 17 mm und Schnurstärke 2,5 mm ist nicht unbedingt notwendig, hält den Trichter aber besser im Einfülloch bzw dichtet dieses ab.
Ich habe den Trichter liegend gedruckt, damit das dünne Rohr aufrecht steht und sauber gedruckt wird. Eventuell muß man mit den Einstellungen spielen damit der liegende Trichter sauber gedruckt wird.
Je nach verwendetem Filament, Druckgeschwindigkeit und Drucker wird die Nut für den O-Ring mehr oder weniger genau gedruckt. Es kann passieren, daß der Rohrstutzen mit dem montierten O-Ring zu groß oder zu klein ist. Einfach entweder die Nut etwas kleiner feilen oder Dichtungsband einlegen. Es geht hier um Zehntelmillimeter daß es paßt oder nicht paßt.
Etwas Nacharbeit wird einem wahrscheinlich nicht erspart bleiben, aber das Einfüllen des Getriebeöls geht wesentlich leichter von der Hand.
Gedruckt mit PLA, 4 Perimeter, Stützen nur auf dem Druckbett, Geschwindigkeit dünne und äußere Perimeter 40mm/sek oder langsamer.
………………………
Angled funnel for the feed gear of the Bernardo P600G. 
An O-ring with an inner diameter of 17 mm and a cord thickness of 2.5 mm is not absolutely necessary, but it holds the funnel better in the filling hole and seals it. 
I printed the funnel lying down so that the thin pipe stands upright and is printed cleanly. You may have to play around with the settings so that the lying funnel is printed cleanly. 
Depending on the filament used, printing speed and printer, the groove for the O-ring is printed more or less precisely. It can happen that the pipe socket with the installed O-ring is too big or too small. Simply either file the groove a little smaller or insert sealing tape. It's a matter of tenths of a millimeter whether it fits or not. 
You probably won't be spared some rework, but filling in the gear oil is much easier. 
Printed with PLA, 4 perimeters, supports only on the print bed, speed thin and outer perimeter 40mm/sec or slower.

Tags