1 / 2
Fan Controlled Silica Dryer for Filament Drybox — image 1
1 / 2

Fan Controlled Silica Dryer for Filament Drybox

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fan Controlled Silica Dryer for a Filament Dry Box with M3 Mounting Holes and Magnetic Container.

Rating
0 / 5
Likes
3
Downloads
13
Makes
0
Views
276
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is the Fan Controlled Silica Dryer for my filament dry box. The original design had one fan that heated and the other that circulated air through silica beads. I decided to the non-heated route and circulate air through silica gel beads. 

The magnetic container allows you to remove the silica beads (so you can exchange them for dry/fresh silica).

 

Materials Needed:

 

Print Settings:

  • Material: ABS (You can use PLA as long as you're not using heat)
  • Layer Height: 0.2mm
  • Wall Count: 3
  • Supports: Yes (For The Bracket)
  • Infill: 20%
  • Infill-Type: Rectilinear

 

Things To Note:

Make sure when you glue you the magnets each of the parts that you have them in the right orientation so they attract.

When mounting the fan, pull off the metal bracket meant for mounting it into the PC Case. When snapping it into the bracket, it is a very tight snug fit.

Length of the M3 screws will vary depending on the thickness of the container that you're mounting it in.

 

 

Tags