CoolAxe Bitaxe Stand

Wouldn't it be cool if you could upgrade the cooling and performance of your bitaxe, simply by placing it in a better stand? Now you can. 

Upgrade any Bitaxe simply by placing it in the CoolAxe Overclocking Stand.

Specifically designed to fit all Bitaxe models, including the powerful Bitaxe Gamma, this stand not only enhances your mining setup aesthetically but significantly boosts performance through an innovative cooling system. Negative pressure sucks the hot air from the ASIC through the stand itself, created by a fan in the back of the stand which vents the air out. This approach allows your Bitaxe to maintain a significantly lower operating temperature, even with stock heatsink and fan. Compatible with two rear fan sizes, 60x60x15 mm and 40x40x20 mm, the 60mm fan obviously yields the best performance. Full access to the back of the Bitaxe also makes the CoolAxe stand the perfect base for modding, like installation of a rear mounted heatsink. 

Test results show the Bitaxe Gamma in the CoolAxe Stand (60mm fan) maintains a median temperature around ~46.5°C with stock cooling and settings and a median temperature of 59°C when running highly overclocked like shown below. Of course this can be improved further by using aftermarket heatsinks and fans, allowing you to push the Bitaxe to its limits. In our testing, a additional heatsink on the back of the voltage regulator proved to be a effective addition to this setup and is highly recommended.

Files:
 

• CoolAxe Stand
• Fan housing for Noctua NF A6x15
• Fan housing for standard 40x40x20 mm fan
• Solid Block which can be used to add weight instead of fan

Print settings:
 

• No supports needed
• Print files as oriented
• Print the Stand from PETG or ASA
• Print the weight block with 100 perimeters
   

Hardware:
 

• 4pcs M3 screws
• Rear fan of choice
• 4 Pin Y Splitter Cable
   

Don't have a 3D-printer? You can buy this stand readily printed here