1 / 5
LEGO Naboo Starfighter (7877) Wall Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Share Alike
A wall mount for a LEGO Naboo Starfighter (7877).
You'll need 1 ~m4x25mm wood screw, 1 8mm wall plug, 1 M4x30 bolt, and 1 M4 nut.
When printing, if using a 0.2 layer height, pause the print at layer 74 to insert the captive m4 nut.
Instructions
- Screw the mount to the wall using the wood screw in the bigger hole and the 8mm wall plug.
- Take R2D2 out, underneath should be a blue lego plate with holes down the center of it.
- Line the naboo starfighter up so the hole underneath where R2D2 was now lines up with the smaller hole on the mount.
- Put the m4 bolt through the smaller hole underneath where R2D2 was and into the mount. Screw the bolt down until the starfighter is fixed down to the wall.
- Put R2D2 back in.
- Finished!
12/07/2024 V2 : Increased length and width of rectangle from 20mm to 20.5mm and from 12mm to 14mm respectively. Moved m4 bolt hole from 7mm to 5.5mm so the m4 nut clears the screw hole properly.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 S1
No
Supports:
No
0.2
Infill:
20
Notes:
Using a 0.2 layer height, pause the print at layer 74 to insert the captive nut.
Category: Decor