Angle Pads for Parallel Clamps
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.20 – €1.46 net (excluding VAT)
For file: Parallel Angle Clamp v21_0.4n_0.2mm_PLA_MK4IS_59m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.33 excluding VAT (range midpoint).
- Weight reported by the author
- 24 g
- Print time reported by the author
- 58.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
These Pads slide onto Bessey Parallel Clamps to give you the ability to clamp angled pieces.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 31
- Makes
- 0
- Views
- 282
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print 2 sets of these pads to slide onto Bessey Parallel Clamps. Then you can use to clamp angled work pieces like tapered legs or joints that are not perfectly 90 degrees. Print the pads with no support with the pad facing the print bed. The Angle Clamp prints with supports on the build plate only. Supports come right off easily. Then Slide the 2 pieces together. It is a tight fit so you may need to flex the pad a little bit. Once together the 2 pieces will slide to any angle you need. Happy Printing!
I included 1 file with both prints and also 2 separate print files.