Drybox Ikea 365 10.6l Container
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two spools very little material waste.
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 72
- Makes
- 0
- Views
- 1,228
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to fit 2 Formfutura Spools. (78 mm wide)
You'll need a bit of M3 Hardware, two lengths of PTFE tubing and for better hold, 8 6x3 mm magnets (had them still from the clicky probe stuff)
An M5 threaded rod and two nuts are also handy to stiffen the inside of the printed beam.
The PTFE stuff rolls good enough, should be durable as well. (Ratrig uses this style as well)
Should be attachable at other heights, fits most spools in my case, could fit others as well.
I'll be stoked if someone got the IKEA 365 Box CAD - This print here fits, but is measured by hand.
(The box in the voron community design git is a different one)
It fits my box, your milage may vary.