Ten Inch Rack Bracket (Generic)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ten Inch Rack Bracket for use with shelves and panels from plywood or similar.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 16
- Makes
- 0
- Views
- 205
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printing panels and shelves for 10-inch-racks often takes a lot of time. So for evaluation purposes (sometimes for regular use as well) I prefer shelves and panels from plywood or plastic sheets I can cut and drill in a fraction of the time I need to print them.
This is a left bracket; for the right hand side you can simply mirror it. The shelf is fixed with two countersink screws (M3), the panel with up to 3 screws (M3).
The rackmount holes are covered by a thin layer of filament, you can poke it through or leave a hole (usually the middle one) closed. The holes then have a diameter of 6.3mm, wide enough for a M6 screw.
Material: PLA, PETG
Layer height: 0.25mm
Nozzle dia: 0.4mm or 0.6mm
Supports: needed only if you print it face down (for a nicer surface, like I tried)