Motorized Lemming Blocker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lemming Blocker with moving head and foot, just like the Blocker's in the Amiga Lemmings game.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 17
- Makes
- 0
- Views
- 143
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Characters & Monsters
- License
- Creative Commons — Attribution — Noncommercial
Off course you need someone to safeguard your printer while you're away, and no one does the job better than a heroic Lemming Blocker!
Fun and a bit challenging build, as I did not make any step-by-step instructions for this. However I think you get a good idea by watching this video:
https://youtu.be/rOU3CUw-3BE?si=o2hIPCFo8YuCSYxa
WARNING/DISCLAIMER:
1: Motor tends to get hot after long time in use, take care.
2: Handle the 220v wiring properly or let someone else do so.
BOM:
1x Microwave turntable motor
M2 and M3 screws
1, 1,5 and 2mm hard steel rods (get them at hobby/RC stores)
Small washer (like ID 2mm) between head & body, lowering noise
Filament (I used PETG all over)
Optional (I think): 5mm magnets and washer for the magnet brake. I dont really think it's needed anymore with the new steel rod sliders with low friction.
Optional: Some plastic friendly grease for the gears/slider might be a good idea to lower noise further. Will soon try this out myself.
Sure hope someone will build it, and would love to see the result. Good luck!