Heat Shield with 40x40mm Air Mixer Fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Heat Shield with 40mm Air Mixer Fan. Remix of gdramos's model on makerworld.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 15
- Makes
- 0
- Views
- 279
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Heat Shield with 40mm Air Mixer Fan. Remix of gdramos's model on Makerworld. The added chamber heater in the K1C was heating up the side so this remix helps spread the heat. The 40mm fan aids in mixing the hot air and keeping the heat shield and surrounding area from getting too hot.
Make sure it doesn't interfere with your build plate or wiring (at all heights).
Works well with K1C with chamber heater. Also works well with the new Creality chamber heater. Just place the shield on the opposite side of the printer.
I don't have CAD software so it was just remixed in TinkerCad. You could probably clean up some of the edges so they line up better if you want.
I uploaded a few different variations of sizes.
I used 4x M3 nuts and 4x M3 x 20mm screws but they stick out the back a couple mm.
Thanks to gdramos for the awesome model. If you have a P1S (and possibly X1C) I would recommend using his model on Makerworld since it's a custom fit.
Edit 11-11-2025: Replaced with rounded edge versions. The model in the pic is the old version with square edges, not the final models uploaded.
