PU-4 magazine for 18х51 mm flange cartridges (BAM, blank, etc.)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Фланцевая обойма к ПУ-4 для 18х51 мм БАМ, холостых патронов и т.д. (под закраину)
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 125
- Makes
- 0
- Views
- 696
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial
Note for non-Russian users:
PU-4 is a launcher for special pyrotechnic cartridges that are used to send emergency and information signals. In the Russian Federation, PU-4 is not a weapon, does not require a license. If PU-4 is illegal in your country, do not use my model.
Printing recommendations:
Layer thickness: 0.1mm
Layer width: 0.6mm
Material: Nylon (PA-12) - recommended, ABS, ABS-CF, SBS, PETG, PLA - not recommended
Supports: Yes (recommended to increase the upper and lower intervals from the model to the supports)
More information on my Telegram channel: https://t.me/my3dguns
Рекомендации по печати:
Толщина слоя: 0,1 мм
Ширина слоя: 0,6 мм
Материал: Nylon (PA-12) - рекомендуется, ABS, ABS-CF, SBS, PETG, PLA - не рекомендуется
Поддержки: ДА (рекомендуется увеличить верхний и нижний интервал от модели до поддержек)
Больше информации на моём Telegram - канале: https://t.me/my3dguns