1 / 5
Buddy3D Camera Mount Adapter for Prusa Official Enclosure
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A sturdy adapter to mount your Buddy3D camera inside the official Prusa enclosure.
- Rating
- 5 / 5
- Likes
- 59
- Downloads
- 343
- Makes
- 10
- Views
- 2,132
- Reviews
- 11
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
This adapter is designed to seamlessly integrate your Buddy3D camera into the official Prusa enclosure. By replacing the original camera support, this printed adapter provides a secure and stable mounting point, keeping your camera well-positioned for clear, consistent footage of your prints. With just one basic printed part and a quick installation.
Assembly Instructions:
Required Hardware:
- 2x M4x10 screws (M4x10r)
- 2x M4 nuts
Recommended Material:
- Prusament PETG (to withstand the higher temperatures inside the enclosure)
Avoid using PLA, as it may deform under the enclosure’s internal heat.
Installation Steps:
- Remove the two original M4x5r (originaly black) screws located at the top of the Prusa enclosure.
- Replace these screws with the M4x10 screws, tightening them as you would normally.
- Leave the protruding ends of the screws exposed inside the enclosure.
- Slide the printed camera mount adapter onto these screw ends from below.
- Secure the mount by fastening the two M4 nuts on the protruding screws.
- Attach the Buddy3D camera to the newly installed adapter. Your camera is now securely mounted and ready for use.
Another creation proudly brought to you by Studio 42.