Openable doors for STEAM LOCO 310.0134 (Print in Place)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A driver’s cab with built-in functional doors (print in place) No assembly required whatsoever. (ENHANCED PART)
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 86
- Makes
- 0
- Views
- 644
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
310.0134: CAB WITH OPENABLE DOORS (print in place)
- Yo, the driver’s cab now got them working doors that print right in place – no extra assembly needed. They pop right outta the printer, already in the right spot.
- But yo, after you remove them supports, be careful when you open them doors for the first time. The hinge is small, so if you ain’t careful, the door might snap right off. When you first pull them out, they might feel stuck to the cab, but just gently work them loose, and they’ll start opening easy. First time you open 'em, hold the door in place with one hand on the hinge side, and with your other hand, slowly start prying open the corners. Don’t mess around too much or you might mess up the hinge.
- Once they’re loose, just start opening and closing ‘em. It might feel stiff at first, but trust me, after like two or three times, they’ll slide like butter.
/////////////////////////////////////////////////////////////////////////////////////////////////////////
Print Setup:
The preparation is almost the same as the original model.
The part must be placed on the print bed upside down.Supports are required, but only in the areas marked in the picture.


- If you want the model to look nice n smooth, I recommend setting a layer height of 0.15mm
- The contact area between the part and the print bed isn’t very large either. If you’re not using an adhesive spray, I’d suggest adding a 3mm inner brim for extra grip
- And don’t forget to place the supports exactly as shown in the picture😉
Enjoy the model! :))
/////////////////////////////////////////////////////////////////////////////////////////////////////////
OTHER PARTS NEEDED TO COMPLETE THIS MODEL AND THE ASSEMBLY GUIDE CAN BE FOUND HERE: 1913s-czech-steam-locomotive-3100134-125
If you like the model, I'd love to hear your feedback! You can rate it, leave a comment, share suggestions or questions, and best of all—post a pic of your print! 🤘😉😎