Pender 3 V2 Neo - A pen holder for your Ender
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A pen holder for Ender 3V2 Neo that does not require any permanent modifications to run.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 39
- Makes
- 0
- Views
- 270
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I wanted to create a pen holder for my Ender 3 V2 Neo that didn't require any disassembly. So, I created the Pender 3 V2 Neo. It does not require any modifications to the printer, and you can use pretty much any slicer to generate the GCODE for it.
This is an early version and it should fit any pen up to about 10mm in diameter. The thicker the better as it will have less play. I've used it with ballpoint pens so far and got some good results but I suspect felt should work as well.
In addition to the printed bracket you will need:
- 3x M3 nuts
- 3x M3 bolts
- 4x magnets (taller is better - the fan shroud can push them out of the way if you misjudged the clearance)
- A pen
To assemble:
- Press an M3 nut into the slots on either side, and inside the hexagonal pen holder
- Thread an M3 bolt into each nut to hold them in place
- Slide the bracket onto your fan shroud - it should sit on top of the bracket for the BL Touch sensor
- Tighten the M3 bolt on the BL Touch side - do not over tighten
- Carefully tighten the M3 bolt on the cooling fan side (You might be able to skip this if it feels snug enough with one screw)
- Home all the axis without paper on the build plate and then raise the Z axis to give you room to work
- Set the Z axis height to 0.2mm and insert the pen into the holder, then tighten the bolt to secure it NOTE - if using thicker paper you may need to use a different layer height, although 0.2mm should work for standard printer paper
- Move the printer on the X and Y axis to test that it is making a line - adjust the pen position as needed
To create the GCODE
- Import your model to your slicer of choice
- The model should be the same as the layer height used to set the pen position
- I've had some success with black and white images using a lithophane generator and cutting off the top layer of it
- Adjust the following settings
- Add z-hop of at least .2mm
- Set bed temperature to 0
- Set nozzle temperature to 0
- Most other settings can stay the same, but you can get different results by adjusting layer width, number of perimeters, and infill pattern
- Modify the start GCODE
- I kept most of the standard start GCODE in Prusa slicer
- I edited any temperature settings to 0
- I removed the nozzle prime line
- I added a line to move the print bed to max Y to make adding the paper easier
- I added a pause command (M25) at the end of the start GCODE
- Slice your model and export your GCODE
- Open the GCODE in a text editor and look for the first G1 command after the custom GCODE that sets the X and Y position
- Copy this step after the pause command
To print
- Ensure you have tested your pen position
- Send your GCODE to your printer and print without any paper on the bed
- When the printer pauses, lay a sheet of paper on the build plate, and secure with magnets in each corner - do your best to ensure it is smooth
- Resume print and wait for your finished work