Saberforge ASP Switch Section for Removable Chassis Builds
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Switch section for removable chassis designs, supporting two 12mm AV switches, NPXL, and 6-trace rotary PCB.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 16
- Makes
- 0
- Views
- 156
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Remixed from WickedSin's linked chassis file, and intended for use with that same chassis (although theoretically this would work with any chassis that uses a ShtokCustomWorx rotary chassis PCB). Holds two 12mm AV switches (spaced for Saberforge ASP switch sections), with built-in holders for a ShtokCustomWorx rotary chassis PCB on one side and a ShtokCustomWorx NPXL PCB on the other side. This will allow your chassis to be fully removable, removing any worries of the switch or pixel wiring retaining the chassis within the hilt.
If you have an ASP build you wish to use this on yourself, adjust the sizing of the bottom "ring" of the switch section by cutting out an appropriate amount of it with the cutting tool, taking care to cut from the top of that section so as to not alter the sizing of the PCB holder at the bottom of that section.
12/21/2024 - Updated model with a wider center channel to better accommodate ease of wire management, and allow for better fit of 12mm AV switches. Retains all previous part compatibility.