Wire Shelf Clip-On Hanger (Prints Flat)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
No support needed, clip this to the face of Wal Mart, Sams, Costco, etc wire shelves. Fits most.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 30
- Makes
- 0
- Views
- 157
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
They snap on to the front or side of the shelf. Sized just right to be springy on shelves… a few brands have smaller rails, so you might print it at 95% or so if you need a tight fit on those.
Since these are flat, you can stack them to print a bunch in a column. Putting them .25-.35 above each other, depending on your layer size, works fine for me. I fill in empty corners when I'm printing something cumbersome :)
I recommend PETG or a strong plastic with a few solid layers. These can technically hold a lot more eight that you're likely to put on them due to the geometry (like, 100lbs would not be out of the question I think, but I don't recommend that much). I'll post some photos of them in use, and maybe an informal tensile test. I recommend keeping it to a weight you're comfortable with knocking off the shelf, just in case.