1 / 3
FluidNC 4 axis foam cutter controller
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Why not building a brand new foam cutter controller with the following requirements :
- able to drive a hot wire
- equiped with 4 bipolar steppers
- driven by standard polulu shields
- and with an ESP32 MCU
- FluidNC driven
- able to "eat" gcode produced by any "foam cutter" software
Let's go it's an easy project which shouldn't cost more than 20$ (without motors) !
This is only "the box" for embeded electronics. All the project is open source/open hardware and fully described on hackaday's page : https://hackaday.io/project/199287-fluidnc-4-axis-foam-cutter-controller
PCB is available on my PCBWay shared project here : https://www.pcbway.com/project/shareproject/FluidNC_foam_cutter_controller_bad9d318.html and if you are new to PCBWay please use this affialiated link : https://pcbway.com/g/o35z4O
Category: Machine Tools