1 / 3
Team Corally 6s wing holder (replaces C-00180-005) — image 1
1 / 3

Team Corally 6s wing holder (replaces C-00180-005)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A more durable wing holder for the Team Corally 6s cars.

Rating
5 / 5
Likes
5
Downloads
40
Makes
1
Views
257
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Durability
The stock ones broke for me in a couple packs, mostly because of wheelies and not even crashes. These have lasted me 1 year in PETG and then finally broke. The TPU ones I replaced them with haven't broken and I don't expect them too.
 

Although I never had this, I will give a disclaimer: With a lot of RC cars some parts are designed to break intentionally, so that other, more expensive parts stay intact. This could be the case with this part, meaning that if you would crash hard and not break this part, the stress would go further in the car and might for example bend the shock tower. This is very unlikely though and I never had this happen, but I just wanted to give a warning also because the different models have different weak points. 

 

Compatibility
This part replaces C-00180-005 and C-00180-005-2. These are used by most, if not all team Corally 6s RC cars. The wing is in almost the same position as stock, but slightly raised. This stops it from hitting the shocks on hard landings. My model is also non adjustable, unlike stock, but that makes it more durable.

 

Print instructions:

I haven't tried in in PLA, but it's probably to brittle. I printed this first in PETG, with 5 or 6 walls and 25% infill, which lasted a year. Now I made a couple changes and it should be even stronger (also in PETG). This current design is intended to be printed in TPU though, I used 95A with 6 walls and 50% infill. The more walls and infill the stiffer it will be, this felt like a good stiffness for me. If you have a TPU with a higher shore hardness you could probably use less infill.

These are designed to work with the stock screws, you do need to add a washer. Insert the nut and washer in the dedicated slots, bolt the  holders on your car and install the wing.

Tags