1 / 1
Candy Dispenser for Mason Jar
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cleaned up geometry of JoHnEyAp’s Candy Dispenser & extended trim blank from CUBE3DWORLD
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 131
- Makes
- 0
- Views
- 814
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Share Alike
JoHnEyAp's base for wide mouth Mason Jars was just what I was looking for so I could print an M&M dispenser. I tuned up the thread area to remove the blanked out original threaded section and drop down the Mason Jar threads. I then took CUBE3DWORLD's trim blank and resized it for this new threaded neck.
Printed in PLA Black Sparkle & Grey @ 0.2mm layer, 2 perimeters, 15% gyroid infill.
The trim blank snaps over the mason jar threads and stays with the jar. Assemble the base with the original parts from sui77's design.