Comgrow SH02 / SOVOL 20 Dry Box Shim and Improved Port Placement
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use this shim to keep the drybox lid open during operation for greatly improved dehumidification and port placement.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 156
- Makes
- 2
- Views
- 1,502
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
The Comgrow SH02 filament dry box is amazing but unless it's kept open a few inches while operating, there is not enough outflow for proper dehumidification. What is FAR WORSE is the placement of the filament ports. This model has 2 ports for ideal exit angles for your filament from the drybox during use.
I have an Ankermake M5 and the ports on the original were literally pulling the drybox across my table until it touched the printer. The revised shim ports reduce strain on the drybox and it stays nice and still during prints.
Yes, there is some increased noise during operation as it is open, but IMO the drybox was unusable otherwise and it is not enough of a noise issue to matter.
Printed with NO SUPPORTS using 0.4mm nozzle with 0.6mm line widths and 0.3mm layer heights, .27mm initial layer height, 3 walls/perimeters, 4 top and bottom layers, 15% cubic infill