Losi Mini JRX2 snow edition
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
wanted to drive my jrx2 in the snow so I made this.Hardware-M2x10 (x2)-M2.5x25 (x2)-M4 washers (x4)-M2.5 nuts…
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 46
- Makes
- 0
- Views
- 582
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
wanted to drive my jrx2 in the snow so I made this.
Hardware -M2x10 (x2) -M2.5x25 (x2) -M4 washers (x4) -M2.5 nuts (x2) -M1.4x5 or 6 (x4 or X8) optional
The m4 washers go on the front "axles" before the adaptor. The m2 bolt go in the little hole above the axle in the adaptor. the wheel nuts you will want to tighten these down quite a bit.
The wheels are a friction fit and work very well if the little nob on top of the main nob are worn down or cut. basically if your tires have worn down tread it will work better. you will be able to tell when you print out the tire. DO NOT cut the whole nob off!
The skis are flat for printability. all you need to do is use a little heat and something round to form the front and or rear of the skis. the "carbides" can be screwed on with the M1.4 screws, but if you don't have those you can glue them. the reason there are so many is because they tent to break off or fall of every once and awhile. (the skis mounted on the car in the picture are the old version)
The tires slightly rub the body under compression but nothing to worry about. this is ideal for a jrx2 with a upgraded power system. will still work with stock but does bog down a decent amount.
NOTE: works super good in light snow or about an inch or 2. will sink in deep fluffy snow.
this is a WIP feel free to fix or mod this (please do)
Category: R/C Vehicles