6.5 inch Sonosub Floor Standing Subwoofer Enclosure

                                           All parts can be printed on a 256 x 256 bed

                                                      Stands two feet tall by ten inches round

Total filament used is about 1.3Kg. The tube is just concrete sonotube cut to length. The port tube is a 1.5inch ID schedule 40 PVC pipe cut to length. I also used 1.25 inch wooden dowels for the base and top portions. Using the sonosub software you can customize and fine tune your bass response for a specific 6.5inch sub speaker of your choosing. Only the port length and sonotube length will change. Software found here. This is a passive subwoofer. Meaning you will have to have an external amp for powering it. A great option can be found here. If you need satellite enclosures to complete a 2.1 setup click here.

This enclosure is specifically designed and tuned for a 6.5 inch Dayton Audio classic subwoofer. It will probably sound great with any 6.5 inch subwoofer with similar power handling.

BOM:

1. 8 inch OD sonotube ( Cut @ 19 inches) OD MUST BE 8inches! go to store and measure then buy.

2. 1.5 inch ID sch 40 PVC PIPE ( Cut @ 8 Inches)

3. 20 M4 threaded inserts

4. M4 screws

5. Wood Screws 

6. 1.25inch wooden dowel. (4 cut @ 38mm, 4 cut at 97mm lengths) 

7. Adhesive

8. Spray paint and primer

9. Speaker terminals