JBL Flip 4 holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A very minimalistic JBL flip 4 holder
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 132
- Makes
- 1
- Views
- 836
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
JBL Flip 4 holder
I needed a secure way of mounting a flip 4 into my boat. This design keeps some of the buttons within reach without the need of taking it out of the holder.
The speaker clicks into place.
Printing instructions
Print with full perimeters, don't use infill. Set perimeters to 12. Print the unit on its side as shown in one of the pictures. This way you are taking full advantage of the filament strength.
Disclaimer
My models are always tested on my own boat. We are currently cruising to the Caribbean and you can therefor assume that we load up the part properly. It is however your own responsibility to use these parts when heading out to sea. Use common sense and print spares if you are not able to print onboard. Especially on longer passages.
Remix
Please remix however you like. If you are not able to design your own parts I do offer a modification service to those in need. A contribution for my effort is however expected. Send me a message on Noforgeinland and I am sure we will figure something out.
https://www.noforeignland.com/boat/sya