Utensil Basket for Bosch Dishwasher

We recently got a new Bosch dishwasher and the basket it came with was too small. This is a replacement basket that fits in the same position. 

I printed it with the normal orientation (bottom on the build plate). However the length is 280mm so that won't work for all printers. In the bottoms down orientation I used manual tree supports on the handle and the hooks. 

The first version I made only had dividers in one direction and that oriented the utensils too diagonally for my liking so I made a version that with dividers in both directions. 

I printed in ASA to hold up to the temperatures in the dishwasher. 

After about 20 cycles I found that some utensils can sometimes slip through the holes, so I made a second version with smaller holes. Its width is also slightly reduced for a better fit in our dishwasher ~2mm.