1 / 7
Qidi Plus 4 2.5" ShopVac Hose Exhaust Adapter — image 1
1 / 7

Qidi Plus 4 2.5" ShopVac Hose Exhaust Adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapt the Plus4 Exhaust port to a 2.5" ShopVac brand hose

Rating
0 / 5
Likes
8
Downloads
52
Makes
0
Views
586
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATED 2/3/25 for slightly more foam gasket squish.

This adapter will allow you to use a 2.5" ShopVac brand hose (commonly available in the USA) as an exhaust hose to vent your printer outside.

The models include custom supports which will provide the best print quality for the small locking tangs. Bracing each tang with your fingers or the edge of a table while you pop the supports out with needle nose pliers will prevent the tangs from bending during support removal.

You will likely need to deburr the exhaust port slots in the Plus4 rear panel to fit the adapter, the panel molding usually has a lot of flash on the small, thin details.

Adapter includes a flat-sided flange which allows you to easily use adhesive foam strips as a gasket material (sized for 5/16" thick, 3/4" wide tape with slight compression).

The Qidi Plus4 back panel is not very stiff, I have found you will want to support the weight of any vent hose to keep the panel flat & sealed to the internal exhaust fan duct (especially when the exhaust air is warm and the panel becomes more flexible)

Testing the setup with smoke matches and monitoring the chamber temperature with Klipper, running the exhaust fan at 100% is ideal when the chamber heater is on. This will vent about 70% of the fumes out the exhaust, where the rest will blow around inside and leak out the poorly sealed chamber. At 110*C bed, the chamber heater on 110V will maintain 60*C at about 15% average power, so the printer can indeed keep up with the maximum intake of fresh air. Large, wide, complex ASA prints do not warp using this setup, so I believe it is thermodynamically sound.

Sealing the tangle-sensor and belt tension access holes on the back panel with tape will solve the three most egregious air leaks in Plus4 Enclosure.

I printed with ASA, hose-end down, with no additional support, 10mm internal & external brims (with 0mm brim distance to object), 0.45mm thick first layer with a 0.6mm nozzle. Locking tangs should be 100% infill. Tangs have not appeared to sag after ~50 print hours at 60*C chamber temp and 100% exhaust fan flow.

Tags