Stand for Fritz!DECT 440
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.54 – €3.10 net (excluding VAT)
For file: 241228_Fritz!Dect440 v12_0.2mm_PLA_MK3S_3h4m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.82 excluding VAT (range midpoint).
- Weight reported by the author
- 30 g
- Print time reported by the author
- 3.07 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Stand for switch and display by avm of type Fritz!DECT 440. Simply place the display on the stand and you are done!
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 166
- Makes
- 0
- Views
- 652
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
The stand for the switch and display Fritz!DECT 440 by avm is shown in photo No. 1.
Simply place the display on the stand and you are done! The display resting on the stand is shown in photo No. 2.
The stand may optionally be used with magnets to make the display sitting on the stand more firmly. The magnets are friction fitted into the two slots. Photo No. 3 shows a magnet resting in a slit. The two magnets have to have dimensions of 10 mm x 2 mm to firmly fit into the slits. The slit is 8 mm deep. Pelase note, that the stand also works well without any magnets.
We used PrusaSlicer 2.8.1 for slicing and Prusa i3 MK3S+ for printing. The settings were:
- Material: PLA, blend peral white from Prusa.
- Layer Height: 0.2mm.
- Orientation: Place the stand one of the narrow sides with a slit. Photo No 4 shows this orientation.
- We used supports of type ‘Snug’. Photo No. 4 shows the printed stand and the supports while still attached to the printing plate.
- We suppressed the generation of supports within the downward facing slit. For doing so, you may right click the object and select ‘Add support blocker’ to generate and position a box in which PrusaSlicer will not generate any supports.
- Infill: 15%