1 / 4
5Kg Spool Roller (optimized)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Optimized version of the 5Kg Spool Roller for higher strength, lower friction, less material. -30% material, -30% time.
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 254
- Makes
- 5
- Views
- 897
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
I had a lot of trouble with too much friction with the existing model, and needed to tweak it to prevent my extruder from skipping steps. While doing so, I ended up re-modeling everything from scratch with the existing model as a base. The FreeCAD files are attached, so you can easily remix this.
Tested to work with the Polymaker 5kg spool, which is 160mm wide. Used with a Qidi Q1 Pro printer.
BOM
- 4x M3x16 (or longer) bolts
- 4x 608 bearings
- 1x SpoolBase
- Standard settings
- 2x SpoolFrame
- Standard settings
- 2x SpoolRoller
- Standard settings, random seam
Instructions
- Determine if your bearings have too much friction. I only had good results once I could spin them freely. If they have too much friction:
- Remove the bearing shields using a metal pick
- Wash the old grease out using soap and water
- Add new teflon spray lube (a thin oil would be fine as well)
- Press the bearings into the roller.
- Place the bearings on a table
- Place a roller onto the bearing, and push down hard (approx 60lbs/30kg) to press the bearing into place.
- If you aren't able to press hard enough, you can also use a rubber mallet or a hammer with some wood in between
- Screw the frame sides onto the base using the M3 bolts
- Gently bend the base to insert the rollers
Failed revisions
