Skoda Scala Phoneboy

Modifications:

I added some objects to get a plain plate ("old-wireless-infill").

Because the solution for liveboy was not practiable for us (different phones). We wanted to use a MagSafe-Wireless-Charger.

(We also tried is with some anti-slip-pads but it wasnt practicable)

Our used charger was this one: https://amzn.to/3ZRa2Yl

To “glue” the MagSafe charger on this phoneboy i cut one of these Tesa PowerStripes on the backside of the charger.

Dont forget to cut them into half or in a size you want to use them.

Used powerstripes: https://amzn.to/3BNlVq9

If you want to rezise the diameter of your prefered charger adjust the object ("wireless-shell") and dont forget to move it into the correct postion you need it.

Next changes i did: Do some infill for cable and USB-End, therefore i added infills:

for cable: “cable-infill-1” →  “cable-infill-2”.

Note: If you have a smaller USB-cable just remove the infills (f.e. a Logitech-USB-Kabel)

In my case i had to do some manual deburring (maybe you can set the object “cable-shell” 1 or 2 mm upper), and it should fit (better)).

If you use a bigger USB-Port, just resize the object ("usb-end").

Using a holder for garage-remote:

We are using this garage-opener: https://amzn.to/4gxWRm3

I added a object and subtracted the volume of the opener (1mm thick walls) and a ellipse to grab it easier out of the holder, but it fits that nice, so you could also just press the left button :)

If you dont need it just remove the objects:

• remote-infill (max size)
• remote-shell (volume of the remote)
• remote-usability (ellipse to take the opener easier out of the holder).

It would be cool to support my addition and use the amazon-affiliate-links :)