1 / 3
Expandable USB holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
Design principles
- This USB holder can be joined with another unit by snap-fit mechanism.
- There are hundreds of USB holder models available, but I didn't want to make 10 slots while I needed only 2 or 3.
- I hate support structures so I avoided any overhang larger than 45 degrees. You don't have to print any support structures.
How to Use
- To connect the units, just push them until it clicks.
- You can disconnect units by one of the following methods:
- Pinch the side walls(the roots of snap-fit hooks) firmly
- Twist them slightly while pulling one from the other
- Push the hooks directly through the hole on the side walls. You may use 1.75mm filament pieces.