Cuttingboard holder / organizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hold up to 4 cuttingboard with a thickness of 10mm
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 100
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a quick and filament saving print for small, medium, and larged sized cuttingboards up to 10mm thickness. With the holes in it saves Filament and helps by drying the boards of after cleaning them. Its only 55mm high (inside is 50mm for the boards), but holds the board really good. (biggest board i use 22cm x 44cm)
It was printed with 0.24mm layerheight and was only with 2 walllayers. Filament used was about 128gramm (Bambulab P1S) it took about 3hours to print it.
Printed in PLA
There are no support needed to print it.
I also put antislip stickers underneath so it stays in place when you put the boards in.
Enjoy :)