Festool D36 Vacuum Accessory Hanger Wall Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Basic wall mount for Festool D36 vacuum accessories
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 45
- Makes
- 1
- Views
- 272
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple hanger to mount your Festool D36 vacuum accessories onto a vertical surface.
Prints as-is and does not require supports. I chose PETG as it is more elastic than PLA, but anything works fine. I upped the perimeters to 3 and infill to 30% to provide a bit more rigidity and strength.
Affix with a #6 countersink screw. Due to print orientation, it is possible to split the part at the layer lines if you tighten down the screw head too much. Be careful.
The accessories are meant to fit nicely without being tight. If you want a more snug fit, scale the model up to 100.5%.
If you want to hold D37 accessories with a twist lock: use this design