1/10 R/C Buggy Carbon Wheels & Tyres set (for Kyosho Triumph)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Vintage Kyosho Triumph (and other 1/10) R/C buggy carbon fiber wheel and tyres set
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 41
- Makes
- 0
- Views
- 330
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a carbon fiber set of wheels and tyres for a vintage Kyosho Triumph buggy.
I believe they would work on other 1/10 r/c buggies but I only tried them on the Kyosho.
Because of the tolerances to correctly fit the bearings and axles it is recommended to use Prusa PC blend Carbon Fiber for the wheels (as the dimentions account for the shrinkage of material). Other materials could be possible to use, but I believe the tolerances will be kinda loose. For the tyres I used Fiberlogy FiberFlex 40D. I believe you can use any other elastic material without problems.
This set is not a copy of the standard Kyosho tyres. They are 95mm in diameter (while the original is 82). So they will make your buggy a bit higher. They are also around 10mm off-center so the trach width of the buggy will increase by 20mm. I like this setup better than the original one.
I would like to try these tyres with a A70 hardness TPU at some point, but haven't done so until now. If I do it, I will update here.
*have in mind that the tyres have an L or R letter embossed. The letters go in the inner side and they indicate left or right tyre respectively.