Logitech Keyboard Kickstand (Shorter Version)

Remix of "Q8Khajah"'s logitech keyboard stand.

I reused the rubber feet from the broken stock logitech keyboard stands and just reattached them to the ones I printed. I used krazy glue to secure the feet more permanently to the printed keyboard stands.

I modified the .stl file and just shrunk down the length of the stand to match the stand that is on my logitech keyboard. This one is a little shorter in length than Q8Khajah's. It's not super good looking in orange, but I happened to have loads of orange filament.

I printed the model pictured above on a sculpto pro2. I also tried on an ultimaker 3. I had better luck on the sculpto.

Print with the "8" facing down.

Some sanding might be required afterward. It's a bit of a tight fit into the keyboard, but it should fit. Sand down the "arms" if you want to be able to fold them in. Alternatively, when slicing you could scale down the X axis to 98% or so, which should make it fit nicely.

Print Settings

Printer Brand:

Sculpto

Printer:

Rafts:

Yes

Supports:

Resolution:

0.15

Infill:

Filament:
PolyMaker PLA Orange

Category: Electronics