HueForge Stained-glass Valentine 1

The next H@llm@rk event is Valentines Day, so I thought I'd try a HueForge Lithophane of a heart and some flowers.  As with all of my stained-glass motif models, this one is in multiple parts, two in this case, a blue-green front piece and a red-yellow rear piece. The design is in PETG, so direct sunlight should not cause a problem with warping.

***IMPORTANT*** All the parts are VERY thin, especially the base layer, so special care is needed to remove them from the build plate. It is probably best to use some glue stick as a release agent for the PETG and to cool them completely before trying.

When joining the parts be sparing with the adhesive, especially in the lighter parts. The adhesive will change the colors if it is not behind the darker parts. I use some around the very edge and a few inner opaque areas to keep the glue from showing. If spread thin and uniformly, it should not show too much.

I used 0.08mm layers to speed printing with minimal lose in detail.

Part 1: (Blue)

Project: Valentine_1_Blue.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x158.2mm in size
You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 1.1mm and the Actual Depth is 0.96mm

Filaments Used:
    PETG Overture White Transmission Distance: 18
    PETG BambuLab Basic Green Transmission Distance: 1.7
    PETG Kaaber Blue Transmission Distance: 3.3
This print uses 3 unique filaments

Swap Instructions:
    Start with White
    At layer #2 (0.24mm) swap to Green
    At layer #3 (0.32mm) swap to Blue for the rest.

Part 2: (Red)

Project: Valentine_1_Red_Yellow.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x158.2mm in size
You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 1.1mm and the Actual Depth is 1.2mm

Filaments Used:
    PETG Overture White Transmission Distance: 18
    PETG Bambu HF Yellow Transmission Distance: 4
    PETG Kaaber Red Transmission Distance: 6.5
This print uses 3 unique filaments

Swap Instructions:
    Start with White
    At layer #2 (0.24mm) swap to Yellow
    At layer #4 (0.4mm) swap to Red for the rest.

If substituting filaments, pick ones with the closest TD values. Use a transparent white, if possible. Otherwise, pick the one with a TD > 10 to minimize the color change it will cause.