Magnetic Door Hinges for Voron 0.2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Now you can not only open and close the door, but also install and uninstall in a matter of seconds
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 36
- Makes
- 0
- Views
- 436
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution
This is inspired by Magnetic Door hinges for Voron 2.4, but adapted to 0.2
Additionally you can use magnets from ZeroPanels to help with the tight seal
The design assumes your total thickness of the panel and foam is about 6mm with the squish for 0.2mm
BOM
- 2x Screw M3x8
- 2x M3 nuts
- 6x Magnet Ø6x3
- VBH tape
- Glue (for better adhesion between VHB and the part)
Installation
Press fit two magnets into the mount base and one into the door part.
Load two m3 nuts into the profile from the top in case you have a BoxZero, otherwise some disassembly might be requires. Attach the base with a screw.
Apply the WHB tape to the door part and place it onto the base. Some CA glue might help with adhesion of the tape to plastic
Place the panel and while holding it, close the hinges, so the VHB would stick to the panel
Print instruction
No support needed