Mounting Plate for DJI RS3 Mini Gimbal (for Sony Rx100 VII and others)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mounting plate that overcomes some of the problems with the native DJI plate when using with a small camera.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 154
- Makes
- 0
- Views
- 558
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
The stock mounting plate for the DJI RS3 Mini gimbal has a lip at one end meant to keep the plate orthogonal to the camera body, but it interferes with the front of the Sony RX100 (and likely other smaller cameras) that have the outside diameter of the lens assembly flush with the bottom of the camera.
Reversing the camera is a bad workaround for some of these because then the lip – in the rear of the camera, prevents the viewscreen from tilting out if it is also flush with the bottom of the camera.
This plate puts an orthogonal alignment lip to one side of the screw slot where it does not interfere with the Sony's lens. It is flat and allows the rear tilt viewscreen to pivot out without problem. (As long as you clean up any remaining supports residue – see my printing suggestions.)
The slot for the thumbscrew is designed with a wider hole with a thin lip inside it at one end. If you push and turn the thumbscrew into this spot carefully, it will cold “thread” or clumsily “tap” that end, so that the thumb screw will not fall out inadvertently when it's not tightened to the camera. (You'll need to turn it counter clockwise to unscrew to remove, as on the stock plate.)
This plate is obviously not as sturdy (stiffness or strength) as the stock aluminum machined plate. It is, however, strong enough for use with a small, light camera like the RX100. It fits a little tighter in the keyed mount slot than the stock one. Be careful when tightening the mount lock lever. If this gets too easy to do, you have potentially broken the mount.
Stay vigilant.
Printing suggestions:
- I printed with PLA because it's a bit stiffer than the PETG I have on hand and prints fiddly detail more cleanly.
- I print it face side down, with the lip top edge in contact with the print sheet. I print supports underneath the rest of the plate. This creates a less slippery plate surface – that increased friction seems to help with putting the camera on the plate.
- Be sure to clean off and lightly sand the plate top so it fits flush to the camera and no stray protrusions inhibit the tilt-out of the viewscreen.
Version 3 of the plate gets rid of a couple of recesses that duplicate cuts from the machining in the stock model. Use confirmed what I originally thought – that these were unnecessary, and in the case of plastic prints, maybe lessen stiffness against the cam action of the tightening lever. Both fit fine and work in my tests.