Multiboard straight peg, 5.6 x 35mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a very straight peg for mounting light tools that have narrow mounting holes to Multiboard
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 109
- Makes
- 2
- Views
- 294
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a more narrow Multiboard peg for mounting tools that are light, but have quite narrow built-in mounting holes (for nails or similar).
All variants:
- 5,6 x 15mm straight peg
- 5,6 x 25mm straight peg
- 5,6 x 35mm straight peg
The peg radius is 5.6mm, and length is roughly 35mm. It has also small chamfer for strengthening the peg (although I have not tested the pull strength) and small notch in the end for preventing tools from sliding off.
Printing settings:
I used PLA for printing, 15% grid infill, 3 perimeters for strength. Printing orientation is side against bed, no supports needed.
Model uses Multiboard Pegboard Click as base.