1 / 5
DT830D stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Snap on DT830D stand with test lead holders.
Features:
- Snap fit, locked in place by pins in the screw hole, no fasteners needed
- Designed to use minimal support (the stand is upside down, make sure to slice it correctly)
- Built in foldable stand, use a piece of 1,75mm filament as hinge
- The base holes are 1,8mm, the stand is 2mm
- The center of mass is low on this model, so the multimeter sits flat on your desk when the stand is closed
- Leads are exposed on the bottom so you can connect alligator clips