Team Raffee - Injora - Jeep Cherokee XJ & Comanche - Body Parts / Update 15.09.2026 Comanche Interior
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A little more detail for a ordinary body. Please read the description.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 78
- Makes
- 0
- Views
- 1,013
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
General Description:
This body is a gigantic pile of smooth plastic. It needs some refinement.
To mount the body on an SCX10 there are also body mounts available here on my Pritables Site.
L and R mean left and right. Most parts are available for both sides; if not, they must be mirrored in the slicer.
Part Description: Side Window Pocket for RotopaX Fuel Can
I printed it in ABS because it can be bonded very firmly to the body with ABS glue. Use whatever you want.
To print the other side simply mirror it in the slicer.
Fits Team Raffee and Injora body (poor copy).
Fuel cans are a lot available as free files. Adjust the size in the slicer so that they fit in the pocket.
Part Description: Magnetic Tailgate - Rear Window
I was looking for a way to change the battery in the Cherokee without removing the body.
Printed it in ABS because it can be bonded very firmly to the body with ABS glue. Use whatever you want.
Use M2.5 screws and nuts for the hinges.
Attention, the letters e-1 and e-2 are different (hole spacing).
Requires 8 pieces of neodymium magnets (20x5x2mm).
I glued the magnets into the provided holes using epoxy.
Part Description: Jeep Comanche Interior
My body mount for the SCX10II required as the basis for the floor. However, it also works with other chassis (Look at the photos to see how the body mounts are glued to the body).
There are full-size seats and half-size seats. Driver figures only fit on the half-size seats. I use Dummy13.
Refer to the photos for assembly instructions.
The seats need to be placed inside before the floor is mounted and are screwed in later after the floor was mountet. It's a bit fiddly, but you can do it.