1 / 7
Carrera Slot Car R2 Banked Curve Barrier Fence + Straights — image 1
1 / 7

Carrera Slot Car R2 Banked Curve Barrier Fence + Straights

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Carrera Slot Car R2 Banked Curve Barrier Fence 2/30 (SHOULDER) + Std Straights

Rating
0 / 5
Likes
40
Downloads
260
Makes
0
Views
1,795
Reviews
0

Updated at source:

Model information

Category
Vehicles
License
Creative Commons — Attribution — Share Alike

Carrera Slot Car R2 Banked Curve Barrier Fence 2/30 (SHOULDER) + Straights

You will need one standard curved fence panel for each section of banked track and one fence end on each side.

Fencing is bent at approx 14.5deg as shown to accommodate the curvature of the banking. As it contours the curve, it straightens out to present flat, therefore it will not fit on a standard flat R2 curve. But I have included Carrera straight length pieces for you to utilize elsewhere if preferred.

Curved piece only fits on outside of R2 ‘shoulder’  of 2/30 banked curve.
1. Fix in place by black micro 15mm bulldog clips on the rear. (remove clip spring handles with pliers)
2. Fix in place with narrow gauge wire (fuse wire) to the ‘hooks’ attached to the rear

There are fence ends standard and shorter. The shorter ones are pictured and will assist in the back end of cars NOT clipping the fence.

More robust than others I found online and will fit a 35mm decal on the front panel wall. 
Use Photoshop to create and bend you decal panel. (approx 330mmx35mm at 14.5deg which equates to about a 10mm offset at the centre). This leaves 8mm at the bottom where the panel is face to face with the track.

I printed my ‘standard’ file on a Elegoo Neptune Plus 4 with a bed build surface of 320x320mm. It uses all the bed. 
I have split the file for smaller printers ‘fence half (2)’

Tags