1 / 2
Guitar Bow "Pick" (No Horsehair Required!) — image 1
1 / 2

Guitar Bow "Pick" (No Horsehair Required!)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

Category
Music
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

This is a super basic design for a guitar bow. I purchased a nice one and did not like how short it was, so I designed this as a longer/simpler version. I printed with 50% infill using basic PLA, and wound sewing thread around the length in place of horsehair (wind until you build up 1/8" of thread, it took me about 10 minutes). I also wound a grip at the top with thicker string, which helps to grip and keep everything in place. 

The notches on each end are to contain the wound thread and keep it in place. You do not need to wrap it with much tension at all, otherwise it will create a “bow”, which makes it hard to go between strings. You play it by “flossing” the strings at different pressures, angles, and speeds and it sounds very similar to a violin and cello depending on which strings you're on. You will need to add rosin before playing, I use this on my cheapest acoustic because it leaves a rosin residue on the strings, but it cleans off easily with a rubbing alcohol wipe and doesn't seem to create any other issues. You can also tap strings with this to get some fun notes as well!

Here is a (rough) audio sample: 

Tags