Sprite Extruder Filament Cutter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mostly stock parts, Zero Y Offset BLTouch mount. Needs new part cooling fan.
- Rating
- 5 / 5
- Likes
- 71
- Downloads
- 402
- Makes
- 4
- Views
- 2,269
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Adapted from the work of @kens96 at the ERCF Community Discord, who in turn based his model off of @TechnikGegg base modules. Accepts the stock Sprite Extruder cooling block and hotend. Modeled with reference from the Kingsidorak Sprite Extruder file, and tested on my own unit. Bends the heating rod connector down a little bit from the extra height, doesn't seem to give any trouble after many hours.
Uses the 683ZZ bearing from the original housing, and the following extra parts
- 2x M3x35 screws
- 1x M3x30 screw
- 3x M3 nuts
- #4 Exacto blade
- Spring
- M10 Pneumatic fitting
Cut my exacto blade to 20mm length, and used a miscellaneous spring i found with OD 5mm and 14mm length, but you can modify the file for your own parts.
x_offset: -45.1
You can check the additional file for reference of assembly.
Needs a custom part cooling fan duct/mount, either for the stock fan or a 5015/5020 fan.
I used this one with a riser block
https://www.printables.com/model/1106005-spriteburner-v2-ender-3s1-cooling-duct-based-on-st