1 / 4
Bolt Sleeve traction board mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Sleeve (75mm) for an M8 bolt with a fatter end to hold traction boards onto the van
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 103
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
I needed something that would allow quick release of the traction boards without spending a fortune on mounts.
I mounted long M8 bolts to the back of the van. I used 100mm bolts which was perfect for amazon special traction boards.
Put the traction boards on, slip this sleeve over the bolt followed by a washer & nut. I used eyelet nuts for quick access.
May add a
Printed in PETG but I Imagine PLA will be fine
V2 - Added bevel on the edge to make it easier to insert