1 / 4
LilyGo T-Embed CC1101 Power Switch Back Shell
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Add a power switch to T-Embed CC1101 by modified back shell.
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 193
- Makes
- 0
- Views
- 2,323
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
LilyGo T-Embed CC1101 is a cheap alternative for flipper zero,but there is one small issue:there is no power switch for device.Even works in deep sleep mode,the battery drained in two days.
So I modified the official shell to add a power switch to it.
- The switch used here is SS12F15V,which is the same one used in the heltec v3 mini case.
- You can break the ground line (or power line if you wish) of the battery and connect it to switch directly,or you may buy a pair of 1.25mm*2p connector to add it between battery and the battery connector.Just be sure you connect the wire with correct polarity.
- Use 4xM2*3 self-tapping screws to fasten the switch to back shell.
- Use 4xM2*8 counter sink screws to fasten the back shell to front shell,or you can use 2 D8*2mm magnet like the official one.