1 / 4
Fritz!Box 5690 Pro Wall Bracket – optimized/short - Fritzbox Wandhalterung
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
brackets/holders for mounting the Fritz!Box 5690 Pro model
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 496
- Makes
- 3
- Views
- 1,941
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Use these brackets to mount the Fritz!Box 5690 Pro to a wall, shelf or cupboard with screws or power strips.
The existing model has been optimized as follows:
- Slopes were added to enable printing on the side without support, reducing the risk of layer separation under vertical load.
- The depth was reduced, placing the device closer to the wall while still accommodating RJ45 cables (primarily intended for use in DSL mode).
- The height of the front clamp was reduced.
Prints well in PLA, 12% infill. No support required.
Mirrored versions are available for added convenience.