Ammo for guns 1108337 V1,2,3

While you can do this with a split and connectors in Prusa slicer the dowels are never exactly in the centre. As well I found 6mm airsoft balls a bit too large. these are 5.8. They work a lot better for the print of the models (  ). To join the just use 1.75mm filament. Cut of a decent length (enough to use for the balls as well as enough to hold on to). Dab of CA glue on the end of the filament then inset into the ball then snip close to the ball (approx 1 mm (enough for line up) place a dab of glue and press together. I can do it with may 68 year old arthritic hands so most of you should be able. This might seem a lot of extra work but the balls come out ROUND and the correct size. You could try to print the dowels but not only unstable they will break due to the print direction