1 / 6
Pwnagotchi Case (Print In Place)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Using Ya Ikou's Pwn-In-Place case as inspiration, I designed a new variant from scratch.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 137
- Makes
- 3
- Views
- 681
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
Using Ya Ikou's Pwn-In-Place case as inspiration, I designed a new variant from scratch.
Built Specifically for this setup:
- Raspberry Pi Zero 2WH
- PiSugar3
- 2.13" E-Ink Display HAT V4
My perceived improvements over the original:
- Made loop hole bigger to actually be able to use a carabiner
- Moved the loop from the bottom to the top so you could leave a carabiner or other attached while still sitting flat on the table.
- Made model thicker so it didn't feel as flimsy
- Covered the Pi Power Port (not needed)
- Added hole to see the Pi status LED
- Added hole to see the PiSugar battery status LED.
It's a snug fit. You'll need to insert the screen side first.
My Print Settings:
- Layer Height: .2
- Infill: 15%
- Paint-on Organic Supports